Calibration of boost pressure, fuel pressure, fuel supply, fuel supply correction, injection phase, request and torque limit, DPF, EGR, AdBlue, sensor calibration, Idle control,
speed limiter, DTC error mask are available for editing.
In total, more than 200 calibrations are supported, depending on the software version.
The module does not correct CS checksums. It is recommended to read and write firmware to the ECU using the Combiloader programmer. This programmer automatically corrects the CS when writing the firmware file.
IMPORTANT, in Wise15C control units, the memory area consists of a calibration area and a configuration area. In the ECULite module calibration maps, parameters from both the calibration area and the configuration area are available, so it is recommended to write the configuration immediately after writing the calibrations.
The writing procedure is described in detail in the help for the Combiloader programmer.